![]() Each pair has 2 cores which are twisted round to reduce interference. We have over 20 colours to choose from in our Mongrel series, and up to three colours can be selected. Therefore please be aware that if you order a length longer than your existing cable you may notice the sound is less clear or more round/warm by comparison, as the signal has further to travel as is affected more by antenna effect etc. Each wire core is sleeved individually inside 550 paracord, which provides the cable with additional strength, insulation and customised look, while maintaining a high degree of flexibility. People often say that silver plated copper sounds slightly brighter than just copper, or that copper alone is warmer, and that is because silver is a more conductive metal - however please keep in mind that other changes to the cable spec in comparison to an existing cable you have can also affect this warm/bright dynamic, such as length, source connector, gauge, and insulation etc - for example longer lengths also sound more warmer/rounded because of things like greater capacitance and antenna effect. The silver plated copper used in this cable is the same wire we use in our -PLUS range of headphone cables and will therefore sound the same in a like for like spec. The litz copper has a larger gauge, as though there are fewer strands the strands are wider, while the silver plated copper has a higher purity and the copper inside is OCC (the litz copper is NOT OCC). The silver plated copper has a Teflon coating around the whole cable while the copper is litz so each strand has its own enamel coating with a polyester filament holding them together, the Teflon coating on the silver plated copper is better for audio but does make it slightly more rigid, while the litz wire is a bit more flexible. Our Mongrel Series cables can be made with either a high purity 80-strand litz copper wire with a polyester filament ( Litz), or a higher purity 100-strand silver plated copper wire with a soft Teflon coating ( SPC). Both are similar in flexibility and tensile strength, though there are a few differences. Option for having the Rean connectors with black and red bands, for left and right, or black for both also available. To conclude the assembly, the outer shell is put in place and the outer screws are tightened.A Mongrel series cable pair of RCA cables, one for L and one for R, made with Rean connectors and a twisted pair of paracord sleeved wires. Once in the pin cylinder, the pin-screw and inner strain relief screw are tightened. Please only wrap it around once and cut off any remains. ![]() The screening (braided or not braided ground strands) is then twisted and wrapped around the cable next to the black insulation. Stripped cable ends are soldered on the contact piece.Ĭables are stripped off their insulation and inserted into the inner pin of the RCA plug. Two strain relief screws provide a strong hold of the cable.įor cable assembly, contacts can be completely separated from their shell. Screw version: Completely closed tubular ground contact for a complete insulation and shielding.Solder version: 2 diameter decreasers to comfortably adjust to various cable diameters.Strain relief provided by one M4-hexagon socket screw 1.5 mm.Outer shell made of black, satin-matt aluminum.Uniquely shaped contact crown to optimize contact pressure and provide a tight connection.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |